|Structure:||Belt Type||Filter Material:||Polyester Wire|
|Pressure:||Mechanical Pressure||Type:||Roller Press Filter|
|Belt Width:||1000-3500mm||Mud Processing Capacity:||10-60T/H|
|Filter Cake Production:||2-85T/H||Sediment Percentage:||75-85%|
|Total Power:||10-33kw||HS Code:||8421291090|
1 meter belt filter press,
1 meter sludge dewatering belt filter press,
belt filter press rollers
1. The frame is reinforced, the appearance is elegant, the bearing seat is firm. The equipment is treated with waterproof and the special anti-corrosion process.
2. The gravity dewatering area is equipped with an advanced distributor to make the material distribution uniform and prolong the life of the filter belt.
3. The high degree of automation of continuous operation from feed to discharge mud cake
4. Different materials are equipped with different structures of filter belts, with high filtration accuracy.
Belt Press Filter Working Principle
The raw material, passing through the distributor, is pre-pressed and dehydrated in the wedge area, and then further squeezed and dehydrated in the large area low pressure drainage area composed of porous drainage rollers. Then, the raw material with a certain degree of dryness is pressed by three sets of high-intensity squeezing, i.e. roller I, roller II and roller III. Then the raw material with extremely low water content is pressed and dehydrated again by the mesh belt at the discharge port. Finally the dry filter cake is discharged. It basically meets the requirements of major varieties for moisture content, and the entire process is subject to extrusion and shear forces.